Qwickset Push Button Door Lock Blicks Red And Doesnt Work

Step 3 pull out the battery pack and push program three times if the smartcode fails to initialize after battery removal and re installation.

Qwickset push button door lock blicks red and doesnt work.

Inspect the inside for signs of rust. Keep holding the button for 30 seconds until the lock beeps and the status led flashes red. The keypad flashes at the same time. The spindle is spring loaded and will retract back when released.

Make sure the turnpiece is in the vertical position. Enter your home with a personalized access code and lock your door with the touch of a button. All code lock out mode is a feature in which the lock rejects all user codes. Press the latch bolt.

Electronic locks are operated by an electronic keypad or touchscreen and have a back up keyway. Press and hold the lock button while installing battery pack. Hold the handleset on the exterior side of the door and make sure the round edge of the spindle faces the door edge. If this doesn t work you need to remove the knob again.

When a user attempts to enter a pin code when the lock is in lock out mode the status indicator flashes red and blue. If it is not pull the spindle out and rotate 180 degrees. The master pin code can still be used to unlock the door. Spray the locking mechanism with liquid graphite to lubricate.

Press the button once more. The door handing process was not executed during installation. View button locations for your lock model. Reinstall the door knob and test.

Hold button until the latch bolt starts moving on its own. Here are the instructions for the door handing.