If after inspecting the track rollers and alignment and your door is still difficult to open and close it may be time for replacement.
Pella sliding glass door hard to open.
First all you need to do is simply give the sliding door track a good scrubbing.
Welcome more light into your home with a pella vinyl fiberglass or wood sliding patio door.
Sliding doors are very heavy very breakable and very expensive this is a two person job.
On some occasions you may notice resistance when you try to open or close the pella sliding doors.
Never leave the glass door unattended.
Clean well and apply a silicon spray.
Clean the track with a vacuum broom or small brush.
If that doesn t help you may need to remove the door itself and clean the rollers on the top and bottom of the door.
The track acts as a guide for the door and also allows roller wheels to help the door run smoothly.
To clean and lubricate the hardware of a sliding closet door use a stiff brush a toothbrush or a hand vacuum to clean dust from the tracks.
Be sure to brush down both sides of the track as well as help scrub out the dirt that exists in the middle move the door along the track to expose the front scrub move the door back to the closed position scrub and so on.
How to adjust the rollers on pella sliding doors.
First slide open the door completely and remove the head stop.
Available in both traditional and contemporary styles find a sliding patio door that best complements your home.
Typically this is the result of dirt or debris inside the sill track.
Lower the rollers by turning the screws in the bottom corners of the door counterclockwise to provide clearances then lift the door and angle the bottom away from the frame to remove it.
Clean the sliding glass door track.
Over time the sliding glass door track accumulates dirt and grime.
Turn the screw.
Standard sliding glass doors all have tracks.
Then lift the door up and out of the track laying it down carefully across two sawhorses.
This slows down your door considerably.
Find the small plastic cap on each edge of the sliding door panel near the bottom.
Sometimes a sliding door sticking can be caused by the door simply being too old and has underwent years of wear and tear.
Sounds like there may be dirt in the tracks.