Pella How To Remove Storm Door Lock

The hinge rail runs vertically along the hinge side of the door.

Pella how to remove storm door lock.

This is a waste of time because the striker plate is still held firmly by 3 screws you can t get to. Had to replace this hardware. Twist the hinge rail screws a quarter turn each counterclockwise using a flat screwdriver. Contacted pella storm door service at 866 809 9460.

This will loosen the tension on the deadbolt allowing it to retract and the door to open. Remove the lock body. The storm door guy does a step by step walk through on how to disassemble a storm door handle in this case specifically a pella select or ashford model. Pretty scary thinking that storm door wouldn t open properly in case of emergency.

The pella contact suggested removing the screw cover strip on the latch side and removing the 5 screws holding the latch side trim. Remove the screws from the latch. If one or both legs are damaged or bent the screw cover strips need to be replaced. Start at the top end and slide your finger down the strip while pressing firmly.

Fit the straight outer leg into the mounting rail first and then snap in the inner leg which may have a hook. If either does not operate when the door is open the hardware needs to be replaced. Steps for replacing the lock and hardware on a storm door. Place the new mortise lock.

Use pencil to mark on strike plate location of deadbolt and spring latch. This loosens the tension in the hinges to make the door easier to open. Reinstall strike plate and test operation. Using an allen key loosen the set screw and remove the interior door handle.

Remove the screws and cover plates. Loosen the set screw. Using a rasp or file carefully remove excess material from bottom of each hole in strike plate about 1 8. Replace the screws and tighten.

To unjam the deadbolt remove the installation screws on the latch rail from the outside. Use the screwdriver to chisel out any wood in the frame that may prevent the door from latching.